Thomson

Please follow these instructions to configure your Thomson router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://192.168.0.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is (blank) The default password is admin

---

Once you log in, please go to Advanced at the top and go to Options to the left side.
From there, please locate SIP and uncheck the checkbox.
Then press Apply at the bottom of the page.

---

Next, click on Forwarding on the left side.
This will show you a Create IPv4 button. (this is actually in the next screenshot)
You will need to get the Private IP from your phone adapter and put it in the Local IP Address
Then, add the Local Start Port, End Port, and others as described in the screenshot.

The information for all ports are in the Port Forwarding Page.

---

Here is a list of ports as an example of what you will see once the ports have been set.

---