Linksys EA-series
Please follow these instructions to configure your Linksys EA-series router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.
- You will need the current IP address of your phone adapter.
- If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
- If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
- If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
- Please write this IP Address down as you will need it in later steps
|
| Attention | |
|---|---|
|
If you are using "Linksys/Cisco Connect", the above login credentials may not work and you will need to use this application to load the Graphic User Interface of the router. |
There are 2 ways of configuring your router. DMZ and Port Forwarding. DMZ will be set for 1 device, while Port Forwarding will utilize ports for any device behind the router.
DMZ
• Once logged in, click on Security.
• Click on the Switch to turn on DMZ.
• Click on Any IP Address.
• Then, click on IP Address on the right to input your private IP address.
• Then, click Apply and OK
Port Forwarding
• Once logged in, click on Security.
• Click on the Apps and Gaming tab.
• Then, click on Add a new Port Range Forwarding.
• You will need to add these ports:
|
Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.
