ZTE ZXV10 W300

Please follow these instructions to configure your ZTE ZXV10 W300 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://192.168.1.1 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is admin The default password is admin – In Brazil, ISP: GVT uses GVT1235 as password

---

Click to enlarge

• Click on Advanced Setup link near the center of the page. By default, the Advanced Setup page displays the Firewall Configuration. • Place a check mark to Disable SPI • Place a check mark to Disable Firewall

---

Click to enlarge

• Click on NAT link near the center of the page.

• Select a virtual circuit (PV0 ~ PV7) and the related NAT status is displayed.

NAT Status: Enabled

---

Click to enlarge

Virtual Server
Single IPs Account
• Assign the ports to the IP address as shown below.

• Port ranges to forward are: • 4200-4200 Protocol: TCP • 5000-5080 Protocol: UDP • 10000-11000 Protocol: UDP • 12060-12080 Protocol: UDP • 16384-16472 Protocol: UDP • 16600-16700 Protocol: UDP Then, click Apply.

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.