Ubee DVW3201B
Please follow these instructions to configure your Ubee DVW3201B router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.
- You will need the current IP address of your phone adapter.
- If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
- If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
- If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
- Please write this IP Address down as you will need it in later steps
|
• Click the Gateway Link near the top of the screen.
• Click Forwarding in the menu on the left.
• Enter the IP address of your phone adapter
• Enter 5004 in Start Port
• Enter 5012 in End Port
• Select UDP for the Protocol
• Ensure there is a check mark in the box for Enabled
• Enter the IP address of your phone adapter
• Enter 5060 in Start Port
• Enter 5061 in End Port
• Select UDP for the Protocol
• Ensure there is a check mark in the box for Enabled
• Enter the IP address of your phone adapter
• Enter 10000 in Start Port
• Enter 10000 in End Port
• Select UDP for the Protocol
• Ensure there is a check mark in the box for Enabled
• Enter the IP address of your phone adapter
• Enter 12060 in Start Port
• Enter 12061 in End Port
• Select UDP for the Protocol
• Ensure there is a check mark in the box for Enabled
• Enter the IP address of your phone adapter
• Enter 4200 in Start Port
• Enter 4200 in End Port
• Select Both for the Protocol
• Ensure there is a check mark in the box for Enabled
• Click apply
Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.
