Kyocera KR2
Please follow these instructions to configure your Kyocera KR2 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.
- You will need the current IP address of your phone adapter.
- If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
- If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
- If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
- Please write this IP Address down as you will need it in later steps
 |
|
• Click Advanced from the menu at the top
• Click Firewall from the left hand menu
• Uncheck the box next to Enable Stateful Packet Inspection
• Change UDP Endpoint Filtering: to Endpoint Independent
• Uncheck the box next to SIP in the Application Level Gateway (ALG) Configuration section
• Click Save Settings at the top of the page.
• Click Gaming from the left hand menu
• Check the box next to the word Enable
• Enter RTP1 for Name
• Enter the IP address of your phone adapter for IP Address
• Enter 5000-5080 for UDP Ports
• Click SAVE
• Check the box next to the word Enable
• Enter Voip1 for Name
• Enter the IP address of your phone adapter for IP Address
• Enter 10000-11000 for UDP Ports
• Click SAVE
• Check the box next to the word Enable
• Enter RTP2 for Name
• Enter the IP address of your phone adapter for IP Address
• Enter 12060-12080 for UDP Ports
• Click SAVE
• Check the box next to the word Enable
• Enter Voip2 for Name
• Enter the IP address of your phone adapter for IP Address
• Enter 16384-16472 for UDP Ports
• Click SAVE
• Check the box next to the word Enable
• Enter Maint for Name
• Enter the IP address of your phone adapter for IP Address
• Enter 4200 for TCP Ports
• Click SAVE
Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.
