Frys FR300RTR
Please follow these instructions to configure your Frys FR300RTR router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.
- You will need the current IP address of your phone adapter.
- If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
- If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
- If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
- Please write this IP Address down as you will need it in later steps
 |
|
• Click Advanced from the menu across the top of the window
• Click FIREWALL SETTINGS from the left hand menu
• Uncheck the box next to Enable SPI
• Change UDP Endpoint Filtering to Endpoint Independent
• Click the box next to Enable DMZ so there is a check mark in it
• Enter the IP address of your phone adapter for the DMZ IP Address
• Uncheck the box next to SIP in the Application Level Gateway (ALG) Configuration section
• Click Save Settings at the top of the page
Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.
