Cisco DDR-2200

Please follow these instructions to configure your Cisco DDR-2200 router to work with PhonePower. These instructions are only if you are connecting your phone adapter to your router.

---

• You will need the current IP address of your phone adapter.
  
• If you have a Grandstream phone adapter please refer to How to receive the current WAN IP Address on a Grandstream.
  
• If you have an Innomedia phone adapter please refer to How to receive the current WAN IP Address on an Innomedia.
  
• If you have an Obihai phone adapter please refer to How to receive the current WAN IP Address on an Obihai.
  
• Please write this IP Address down as you will need it in later steps

---

Open a web browser Enter http://192.168.1.254 into the address bar and press enter Log into the router. You will be prompted for a username and password. The default username is admin The default password is admin or 1PTV-ADM1N

---

• Click Home Network
• Click IP Networking
• Click NAT
• Click DMZ Host
• Enter the IP address of your phone adapter
• Click Apply

---

Note: If you are unable to place a call after 15 minutes, or any other irregularities appear, please contact our support department for additional assistance.