Physical Setup Instructions for Obi302
From PhonePower Knowledge Base
Before you begin, make sure that all of your hardware is powered off, including the router, PC’s, switches, and cable or DSL modem. |
- Connect your cable or DSL modem’s Ethernet cable into the Obi302’s Internet port.
If you have a router as well as a modem:
- Connect one end of the Ethernet cable that came with your Obi302 into the LAN port of the Obi302.
- Connect the other end of that cable into your computer or the Internet/WAN port of your router.
- Connect the RJ-11 telephone cable connected to your telephone into Phone 1 port on the Obi302.
- Reconnect the power into your cable or DSL modem and wait until the lights stabilize on that device.
- Connect the included power adapter to the Obi302 power port and plug the power adapter into an electrical outlet in the wall.
Wait between 10 and 15 minutes so the device can complete the initial booting and automatic provisioning process, and the lights stabilize.
Obi302 Light Status
- Pick up the handset attached to the Obi302, Phone 1 port and place a test call.
- Turn on your computer or router.
- Open your web browser and confirm you can browse the internet.