Initial-Sync-Instructions-for-the-Grandstream-HT 812V2

---

To configure your HT 812V2 to work with Phone Power's service, please follow these instructions.

You should reset the device to the default factory configuration. To reset the device to the default factory configuration:

Press and hold the reset button located on the back of the HT 812V2.

Pick up the handset and dial ***02 and Write down the reported IP Address.

With that IP address you should be able to log into the Device from a computer system that is also on the same network.

Enter username and password for the device. If you reset your device to factory defaults, the Username is Admin and the password is on bottom of HT 812V2

Click on Maintenance then Upgrade

Select Config File

Set "Config Upgrade via" to HTTP.

Set Config Server Path to:

provision.phonepower.com:4192

Set Config File Prefix to:

HT502Prov.php?hwid=

Click Save And Apply at the bottom of the page.

Power off the Grandstream device for 15 seconds

Power on the Grandstream.

If you are unable to place a call after 15 minutes, please contact our support department for additional assistance.